Doepfer A-100(~ 40 MB) - Manual (Page 661)

doepfer System A - 100 MIDI-CV/SYNC Interface A-190
7
Changing parameters
There are two ways of changing parameters on the
A-190: either manually, or by sending the appropriate
MIDI messages, which the A-190 ‘learns’. Whenever
possible, use the latter method, ‘MIDI learning’. In
chapters 4.2 and 4.3, the symbols
M M M M (MIDI learning)
and m m m m (manual) show the different methods possible.
In manual mode, use the INC button 3 to increase a
parameter by one, and the DEC button 4 to decrease
it by one. All the LEDs flash once together each time a
change is made.
In MIDI learning mode, parameters are changed by
sending appropriate MIDI messages to the A-190. For
example, in Config menu 1, the MIDI message “PROG
CHANGE 3" switches CV CHAR. (the type of pitch
control voltage sent out) to V/Octave.
Switching back to performance mode
When you’ve made the change to the parameter you
wanted to alter, you can either change other parame-
ters in the same menu, or go on to the next menu by
pressing MENU button 2. Repeatedly pressing the
MENU button takes you through all the menus, and
then back to performance mode - signified by all the
menu LEDs (8) being off (see the diagram at top left).
H If you’ve edited a parameter in one menu
group, and want to edit one in the other, it’s
necessary to go back to performance mode
first. Then you can press the Group button 1
to switch to the other menu group.
H You can find a table showing all the parame-
ters in the CONFIG and PERFORMANCE
menus, as well as all the MIDI controllers,
on page 23.
MENU MENU MENU
Edit-Mode Performance-
Mode
...