Doepfer A-100(~ 40 MB) - Manual (Page 439)

doepfer System A - 100 LFO 2 A-146
1
1. Introduction
Module A-146 (LFO 2) is a Low Frequency Oscilla-
tor, which produces periodic control voltages over a
wide range of frequencies.
The LFO can be used as a modulation source for a
series of modules (for instance pulse width and/or
frequency modulation of a VCO, modulation of a VCF
cut-off frequency, amplitude modulation with a VCA).
Three outputs are available, with different waveforms:
sawtooth / triangle; square wave, and positive-
voltage square wave.
The waveform is continuously adjustable from rising
sawtooth, through triangle to falling sawtooth. The
same control affects the pulse width of the square
wave.
A three-way switch can select one of three frequency
ranges, spanning from one cycle every few minutes, at
the lowest, up to audio frequency at the highest.
Frequ.
LFO 2
Frequ.
Range
Wave
Form