Doepfer A-100(~ 40 MB) - Manual (Page 206)

A-112 Sampler System A - 100 doepfer
16
right (cw position 10) it corresponds to the whole
memory (64 kbyte or 256 pages). During the adjust-
ment of Len with the tune control no external voltage
should be applied to the CV input ".
Gate = high:
As soon as the gate goes high the current position of
the tune control is used to set the Len value.
For the different effect modes the following notes also
apply:
Delay, Pitch Shift:
The factory setting is 4 kBytes (i.e. 16 pages). This
corresponds to a tune control setting of about 0.5.
Reverse Delay:
The factory setting is 64 kBytes (i.e. 256 pages).
This corresponds to tune control setting 10.
The reverse delay effect seems to go very strange with
tune control settings of about 1.5 down to 0, i.e. the
reverse delay becomes a normal delay, but with ex-
treme distortion.
4. In / Outputs
! Audio In / Wave-CV In
At this socket the audio input signal is patched in (i.e.
the signal to be sampled or used for effects). This is a
line level input (+/-2.5V or 5Vss). Note that the audio
signal must be at line level – microphones won’t give
enough output.
H Exception: In wavetable play mode this is
the wavetable control voltage input -
2.5...+2.5V (not an audio signal input)!
" CV In
Control voltage input for sampling frequency du-
ring record, or pitch/tune during play. This input
follows to the 1V/oct. standard and has 1/4 semitone
resolution.
H The control voltage applied to CV in " is
internally added to the voltage generated by
the tune control 2.
§ Gate In
At the Gate input § the gate signal is patched in. The
function depends upon the mode selected.