Doepfer A-100(~ 40 MB) - Manual (Page 222)

A-113 Subharmonic Generator System A - 100 doepfer
8
4. In / Outputs
! In
Socket ! is the subharmonic generator’s audio input.
Connect up the signal you wish to use as master
frequency signal (normally the rectangle output of a
VCO).
" Foot Ctr. In 1 • § Foot Ctr. In 2
The gate inputs " and § are used to select the
mixture. Any gate type signals may be used (e.g. Foot
Controller, Sequencer gate outputs, MIDI interface)
(see fig. 7).
Fig. 7: Selecting mixtures with gate signals
(0: gate = low or no gate signal applied,
1: gate = high)
The mixture is displayed with the decimal points (see
chapter 3, fig. 5).
$ Single Out
Sockets " outputs the single subharmonic of the
respective frequency divider. The attenuators 4 do not
affect the level at these sockets.
% Mix Out
At output § the mix of the 4 subharmonics adjusted
with the 4 attenuators 4 is available.
Foot Ctr.
In 1
Foot Ctr.
In 2
Mixture Display example
0 0 "00"
0 1 "01"
1 0 "10"
1 1 "11"