Doepfer A-100(~ 40 MB) - Manual (Page 692)

USB/Midi-to-CV/Gate A-190-4 System A-100 DOEPFER
4
In- / Outputs:
1. USB port: Input for MIDI data.
Please do not use MIDI IN socket and
USB port in parallel!
2. MIDI IN : Input for MIDI data (DIN socket)
3. MIDI THRU : Output to loopthrough incomming MIDI
data to another MIDI device connected
here.
4. Clock : MIDI clock signal output (original or
divided rate).
5. Reset : Reset signal output:
MIDI-Start or Continue: low/no voltage
MIDI-Stop: high voltage.
6. Gate : GATE signal output; will usually be
connected internally to the A-100 system
bus (INT.GATE line) but may be
disconnected.
7. CV 1 : Output for control voltage 1 (D/A
converter 1); usually connected internally
to the A-100 system bus (INT. CV line)
but may be disconnected if desired. May
be used mainly for controlling VCO pitch.
8. CV 2 : Output for control voltage 2 (D/A
converter 2). May be used to control
additional parameters just like e.g. VCF
cutoff or VCA level.
Module width:
6 HP
Module depht : 30 mm
Current
consumption: 200 mA