Jeppesen FliteDeck 3 - Manual (Page 30)

Installation and Activation
33
New JeppView Users Start Here
If this is your first time using JeppView and JeppView FliteDeck, or if you are
currently running JeppView 2, follow these steps. Ensure that you have
administrative permissions on your computer before starting.
Insert the Program CD into your computer CD-ROM drive. If the setup program does
not start automatically, browse to your computer CD-ROM drive and double-click
setup.exe. To install the JeppView programs on your computer, follow these steps:
1. On the Welcome screen, click Next.
2. Read the information in the Installation Overview window and click Next.
3. Read the license agreement and accept the terms, and then click Next.
IMPORTANT
Accept the license agreement. Because JeppView is designed for
use on a combination of home, office, laptop, and aircraft
computers, the license agreement allows you to install the
JeppView and FliteDeck components on various combinations of
up to four computers for your own personal use. Under no
circumstances should this software be used by more than one
person at the same time.
4. In the Pilot Information dialog box, enter your name and 16-character or
alphanumeric serial number from the front of your CD album, and then click
Next.
5. Select the programs to install. You can install JeppView, FliteDeck or both.
6. Select the path in which to install JeppView and FliteDeck and click Next.
Jeppesen recommends that you use the default folder or a location where
other Jeppesen programs have previously been installed. If you want to use
a different drive or folder, click Change, and then type the path or browse
to the folder that you want.
7. Click Next through the remaining screens, accepting all default options.
8. When the installation is complete, click Finish. A dialog box appears
instructing you to insert ECD Disc 1. If your computer requires a reboot, do
so before moving to that section below.
Existing Users Start Here
If you changed your JeppView subscription to update your MFD system, or you are
currently using JeppView v3 with a different serial number, you must deactivate your
current version. After you have deactivated JeppView, the installer will ask for your
new JeppView serial number. You do not need the Program CD.
To deactivate JeppView:
1. Open the JeppView program folder (the default location is
C:\Jeppesen\JeppView3
).
2. Double-click deactivate.exe.