Jeppesen FliteDeck 3 - Manual (Page 132)

Plan Page
135
• FliteDeck displays a magenta line from your present position to the
Direct to waypoint.
• The Supplemental Track Indicator (STI) and Flight Information blocks
(enroute nav page) guide you to the Direct to waypoint.
To go direct to a waypoint in your route, just select a waypoint from the Route
Waypoint list.
IMPORTANT The Direct To button is only available if FliteDeck is receiving
a valid GPS position, or if the GPS simulator is on.
Notes about Direct to Operations:
• Direct to operations are temporary.
• The Direct to route is not displayed on the Plan page.
• The existing route is not changed by a Direct to operation (unless it was a
Direct to route).
• You cannot save a Direct to route.
Canceling Direct To and Resuming Navigation on your Route
To cancel the Direct To routing:
1. Select the Plan page.
2. Click the waypoint in the route to resume navigation.
3. Click Set Active Waypoint.
Loading a Previously-Saved Route
To load a route saved from JeppView, FliteStar, JetPlanner or FliteDeck:
1. Click Routes (F12). Available routes are those that have not been hidden in
the FliteDeck Setup program (see Routes Tab for more information).
See Transferring your RoutePack to the FliteDeck Computer for a procedure to move
RoutePacks from another computer.
The Routes and Waypoints block displays a list of the available routes. Five routes
are listed in this example: