Jeppesen FliteDeck 3 - Manual (Page 100)

FliteDeck Principles
103
large changes to speed.
• Click d next to VS to decrease the vertical speed by 10 feet per minute and
click u to increase the vertical speed by ten feet per minute. You can also
press D and U on the keyboard.
• Hold SHIFT to change the vertical speed in 100-feet per minute
increments.
• Hold CTRL to change the vertical speed in 1-foot per minute
increment.
• Click the down and up arrow symbols next to Alt to change the altitude by
100 feet, or press the DOWN ARROW or the UP ARROW key.
• Hold SHIFT to change the altitude in 1,000-foot increments.
• Hold CTRL to change the altitude in 10-foot increments.
Using GoTo
If you have a route loaded, FliteDeck normally sets the simulated aircraft location at
the departure airport. To place the aircraft symbol at a specific location, do the
following:
1. Place the simulator in the On mode.
2. Click the desired location on the chart. Notice the latitude and longitude,
designator for an airport, VOR, NDB, or intersection appears on the Status bar
and in the Sim Trainer GoTo block.
3. In the sim trainer control box, click GoTo to move the aircraft symbol to the
desired location.
You can also use the Waypoint List to move the aircraft symbol:
1. Go to the Plan page.
2. Click Clear Waypoint (CLR) to clear the Enter Waypoint text box.
3. Select a waypoint in the Route Waypoint list. FliteDeck marks that waypoint
with an asterisk (*).
4. In the GPS sim trainer control box, click GoTo.
IMPORTANT
When you are finished practicing with the GPS Simulator Trainer,
return to the FliteDeck Setup program, select the GPS tab, and
enable your actual GPS. See GPS Tab .
The GPS Status Indicator