Jeppesen FliteDeck 3 - Manual (Page 197)

JeppView FliteDeck User's Guide
200
1. Connect your weather receiver and ensure it has power and it is turned on.
2. In the Interactive services dialog detection window, click Show me the
message. When you click Show me the message you will switch to session
0 where you can see your interactive service.
3. Click File > Exit in XmLink.
4. If necessary, click Yes, Exit.
5. Click Return now.
6. Double-click the XmLink icon to verify you are receiving weather data (do not
close XmLink). If you are receiving weather data, the XmLink icon will also
blink in your system tray (by your clock).
7. Start FliteDeck .
If you do not care about seeing the XmLink application with your connection
information, you can leave it running in session 0. If you do leave it in session 0, you
will have to use the Interactive services dialog detection window to check on your
signal strength. The only way to have the XmLink application on your desktop for
easy access is to use the procedures identified above.
After the Jeppesen Weather Controller (JWC) and XmLink are installed and
configured using the steps outlined in Initial Installation and Configuration , your
configuration is complete. Every time your computer starts, JWC automatically
initializes XmLink and starts to collect weather data from your receiver when it is
connected. You do not need to revisit XmLink unless changes have been made to
your XM subscription, weather receiver, or COM port.