Jeppesen FliteDeck 3 - Manual (Page 121)

JeppView FliteDeck User's Guide
124
Repeat this procedure, appending the rest of the waypoints to your route.
NOTE
In the Setup program Routes tab, the Confirm route changes option
lets you to examine your changes on the route list and chart before
committing to them. If you would prefer to skip the Execute step, run
the FliteDeck Setup program, click the Routes tab, and clear the Confirm
route changes check box.
Adding Waypoints by Typing Their Names
If you know the waypoint name or designator, you can enter it into the Enter
Waypoint Text box and add it to your route. See
The Enter Waypoint Text Box to
review the procedures for entering waypoints.
1. Click Clear Waypoint (ESC) to clear any text in the Enter waypoint text
box.
2. Type in the name or identifier of any airport or navaid.
• If FliteDeck correctly matches what you type (shown to the right of the
Enter waypoint text box), proceed to add the waypoint, step 3
below.
• If FliteDeck does not correctly match what you type, click Select
Waypoint and select the waypoint you want from the Select Waypoint
list.
• If FliteDeck indicates [No Waypoint], go back to Step 1 and try
entering the waypoint differently.
3. Click Append Waypoint (F9).
4. Repeat this procedure, appending the rest of the waypoints to your route.
Using the Active Route from your GPS
When connected to a GPS unit that outputs route information, FliteDeck
automatically uses the active route from the GPS receiver. This occurs if you have
entered a route into your GPS and made it active. If the GPS active route is not the
route you want to see in FliteDeck, click Routes and choose something else from the
Select Route list.