Metrohm Vision Manual - Manual (Page 94)

92 ▪▪▪▪▪▪▪
• Network cards: Metrohm does not recommend the use of two network cards. If multiple
communication channels are required, use a hub.
3.16.7 Changing the IP Address
Changing the IP Address of the computer
• Use the IPConfig Utility in Windows
Changing the IP Address of the XDS instrument:
• Go to Windows/Accessories/Notepad
• Enter the following exactly as shown:
• [Set IP]
• Do Update=1
• IP=XXX.XXX.XXX.XXX
• Subnet=XXX.XXX.XXX.XXX
• Optionally add the line
• Gateway=63.121.141.1
• This is usually done by IT people who know if this line is required.
• Fill in IP address you need to replace XXX. The same for Subnet mask.
• Save the file as “xds_set_ip.ini” in the Vision directory.
• Open Vision and go to Status on the tool bar.
• When the Status dialogue is displayed, click on Update. A message “The IP address has been
changed successfully” will be displayed
• Close Vision, recycle power to the instrument and re-open Vision. You are ready to go!