Metrohm Vision Manual - Manual (Page 195)

▪▪▪▪▪▪▪ 193
5. In the Add User window type in the user ID and user name. Choose the access level from the
drop-down list. Click on OK when done.
6. Note the user’s password (it can be changed later).
7. Close the System Security window.
7.3.2 Deleting a User
Only a System Manager can delete an existing user. To delete a user follow these steps:
1. Make sure you are logged into Vision as a System Manager.
2. If necessary, enter the DA mode.
3. Click on Configure/Security. The System Security window shows up.
4. Highlight the User ID to be deleted by clicking on it.
5. Click on Delete.
6. Confirm the deletion.
7. Close the System Security window.
7.3.3 Editing a User
Only a System Manager can edit an existing user. To edit a user follow these steps:
1. Make sure you are logged into Vision as a System Manager.
2. If necessary, enter the DA mode.
3. Click on Configure/Security. The System Security window shows up.