Metrohm Vision Manual - Manual (Page 80)

78 ▪▪▪▪▪▪▪
• Click on a file to highlight and select it.
• You can select multiple files by holding down Control key while clicking on the files.
• You can select a range of files by clicking on the first file in the range, and then holding down
the Shift key and clicking on the last file.
• Click on Open when all the files you want to import are selected.
Vision creates a separate DCM for each imported file. Do not be surprised by the number of DCMs in
your project after the NSAS files import. The DCM may not truly reflect how the original data was
collected as this information was not part of the original NSAS file.
Vision allocates a buffer to hold the names of spectral files to import. The size of the buffer is
sufficient to import 100 NSAS files with typical name length. If the buffer gets overfilled, import of
NSAS data is not successful. In this case import your files in several smaller groups.
3.12.2 Importing ISI Data Files
Vision allows for import of data files created and saved in ISI software. ISI files have an extension
*.NIR and have to match the Vision supported data points spacing to be successfully imported.
• In order to import an ISI data file click on File/Import/ISI from the Data Acquisition Mode. The
following window opens:
• Browse to the file location, select it, and click on Open.