Rockwell Automation 7000L PowerFlex Medium Voltage AC Drive (C Frame) - Classic Control - Manual (Page 343)

Functional Description 5-35
7000 “C” Frame 7000L-UM300I-EN-P – June 2013
Analog Outputs
A total of thirteen programmable analog outputs are provided on
various boards. There are two analog outputs on each SCB and 1 on
the CIB, which are intended for diagnostic purposes and are available
as test points for connection to an oscilloscope or chart recorder.
These analog outputs are 8-bit, non-isolated, with a range of -10V to
+10V. The CIB has one isolated 4-20mA or 0-20mA analog output
and 7 non-isolated analog outputs for connection to external devices
such as meters or isolation modules. The allocation of the analog
outputs is shown below:
No. Output Board Description
1 Rect_TP1 SCBL DAC_TP1
2 Rect_TP2 SCBL DAC_TP2
3 Inv_TP1 SCBM DAC_TP1
4 Inv_TP2 SCBM DAC_TP2
5 Cib_TP4 CIB CIB_TP4
6 4-20mA CIB Connector J4b
7 CIB_Port1 CIB Connector J5b
8 CIB_Port2 CIB Connector J5b
9 CIB_Port3 CIB Connector J5b
10 Meter Port 1 CIB Connector J9
11 Meter Port 2 CIB Connector J9
12 Meter Port 3 CIB Connector J9
13 Meter Port 4 CIB Connector J9
Any parameter or variable can be assigned to any analog output. The
variables are scaled by using the corresponding scaling factor.