Rockwell Automation 7000L PowerFlex Medium Voltage AC Drive (C Frame) - Classic Control - Manual (Page 187)

Operator Interface 3-65
7000 “C” Frame 7000L-UM300I-EN-P – June 2013
View a Directory
The directory of a flashcard is shown by pressing the [F7] key on the
TRANSFER screen. The directory shows the filename and
extension, along with a date and time stamp of when the file was
created. A screen typical of Figure 3.89 will be shown.
Figure 3.89 – Typical Directory
Any screen or operation that requires a filename to be entered or
picked from the directory uses this DIRECTORY screen. It is
always obtainable from the [F7] key on any applicable screen.
When the directory is entered from the TRANSFER screen, all files
will be shown. When entered from one of the operations screens,
only the files that are relevant to the operation being performed will
be shown.
Only the root directory of the card is used, as sub directories are not
supported in the operator interface.
Select a filename
When working with existing files on the flash card, it is necessary to
pick a file from the directory in order to use in the operation being
performed. When the DIRECTORY screen is entered, all files that
are relevant to the operation are displayed. The [cursor up] and
[cursor down] keys are then used to select the desired file. Pressing
[Enter] will select the file and proceed with the operation.
Press the [F10] key to abort the selection operation and return to the
previous screen without continuing with the operation.