beautypg.com

Overview, Keypad – Rockwell Automation 7000L PowerFlex Medium Voltage AC Drive (C Frame) - Classic Control User Manual

Page 125

background image

Operator Interface 3-3

7000 “C” Frame

7000L-UM300I-EN-P – June 2013

Overview

The operator interface used on the

PowerFlex

7000L Medium

Voltage “C” Frame Drive is that of the PanelView 550 terminal
(Figure 3.1). This terminal however does not behave as a PanelView,
as only the hardware for the operator interface has been utilized.
The PanelView software has been replaced with unique software to
tailor it to the requirements of the Medium Voltage Drive, and its
faceplate has been modified (Figure 3.1).

4

3

2

1

Figure 3.1– PowerFlex 7000L Operator Interface Terminal

Keypad

The keypad of the operator interface consists of two rows of five
function keys (item 1 of Figure 3.1) located below the operator
interface 's display area (item 4 of Figure 3.1). In the lower right
corner of the operator interface are four keys, which will be referred
to as the cursor keys (item 2 of Figure 3.1). Above the cursor keys
are data entry keys consisting of the numeric values 0-9, a decimal
point (.), a negative (-), a backspace key and a data entry key (item 3
of Figure 3.1).


All keys are of a membrane type. The key is executed upon release.

Function (Softkeys) Keys


Along the bottom of the display area is one or two rows of
'Softkeys'. These 'Softkeys' represent the physical function keys.
The function of the actual keys will vary between displays. The
bottom row of keys (i.e. F6-F10) is always shown. The upper row is
shown only if they are required for keys (F2-F5). Thus a single row
of 'Softkeys' always refers to the keys F6-F10.