Rockwell Automation 7000L PowerFlex Medium Voltage AC Drive (C Frame) - Classic Control - Manual (Page 123)

Chapter
3
7000 “C” Frame 7000L-UM300I-EN-P – June 2013
Operator Interface
Chapter Objectives
This chapter describes how you use the operator interface to modify
and obtain information contained within the drive. In this chapter
you will learn how to:

Modify information associated with the initial drive setup.
 View: - drive parameters,
- drive status.

View & Reset Alarm Conditions.

Request printouts of the information in the drive.

Perform diagnostic trending.

Modify the operation of the operator interface.
The chapter deals only with the operation of the operator interface.
Specific references to a particular parameter are only for illustrative
purposes. Refer to Medium Voltage AC Drive Parameters •
Technical Data (Publication 7000-TD001_-EN-P) for information
about the actual 'tags' within the drive and their use.
Terminology
Parameter – A memory location within the drive to which data may
be written to or read. Setting a parameter (i.e. writing to it) will
modify how the drive behaves. Prior to using the drive a number of
parameters must be set. Additional parameters may be changed
while the drive is in use in order to adjust its operation, (i.e. the
speed could be changed via a parameter).
Read-only Parameter – A memory location which can only be
read. A read-only parameter contains real-time data and is used to
read the current conditions within the drive, such as running speed.
Tag – A generic reference to either a parameter or a read-only
parameter.
PanelView 550 – The PanelView 550 is a product marketed by
Rockwell Automation consisting of a hardware terminal and a
software package, integrated into a single product. The Medium
Voltage Drive only uses the hardware portion of the product and has
replaced the software package.