Rockwell Automation 7000L PowerFlex Medium Voltage AC Drive (C Frame) - Classic Control User Manual
Page 161
Operator Interface 3-39
7000 “C” Frame
7000L-UM300I-EN-P – June 2013
Enumerated Value
When the parameter is an enumerated value, the MODIFY
PARAMETER screen typical of
Figure 3.44
will be displayed. This
screen shows:
•
the name of the parameter for which you are make the changes
(
i.e.
Operating Mode)
•
the tag code for the parameter (
i.e.
4)
•
the actual value of the parameter contained in the drive.
Figure 3.44 – Modify Enumerated Value
Figure 3.45 – Option List Viewed on Single Page
To be allowed to make changes to the parameter, the
operator
interface must
be set to an Access Level
other than
'Monitor'. (You
will be able to view the screen
;
however, pressing the data entry
keys will have no effect). If you are not in the correct level, press
the [F8] key in order to gain access to the parameter. Refer to the
section entitled
Enter/Modify an Access Level
for further
information on the operation to change the level.
Having gained access, press the up or down cursor keys to obtain a
list of possible options to select from. Use the up/down arrow keys
to move the highlighting to the desired option
(Figure 3.45)
. If more
options exist then what can be displayed on a single screen, a
triangle or inverted triangle symbol will indicate in which direction