Lenze ECSCMxxx - Manual (Page 4)

l
4 EDBCSXM064 EN 11.0
Scope of supply
Position Description Quantity
A ECS LM... axis module 1
Accessory kit with fixing material corresponding to the design ( L):
l "E" − standard panel−mounted unit
l "D" − push−through technique
l "C" − cold−plate technique
1
Mounting Instructions 1
Drilling jig 1
Functional earth conductor (only ECSDM...) 1
)
Note!
The ECSZA000X0B connector set must be ordered separately.
Connections and interfaces
Position Description Detailed
information
X23 Connections
l DC−bus voltage
l PE
^ 54
B LEDs: Status and fault display
X1 Automation interface (AIF) for
l Communication module
l Operating module (keypad XT)
^ 79
^ 191
x2 PE connection of AIF
X3 Analog input configuration ^ 69
X4 CAN connection
l MotionBus (CAN) / for ECSxA: System bus (CAN)
l Interface to the master control
^ 80
X14 CAN−AUXconnection
l System bus (CAN)
l PC interface/HMI for parameter setting and diagnostics
X6 Connections
l Low−voltage supply
l Digital inputs and outputs
l Analog input
l "Safe torque off" (formerly "safe standstill")
^ 64
^ 68
^ 69
^ 70
S1 DIP switch
l CAN node address
l CAN baud rate
^ 197
X7 Resolver connection ^ 86
X8 Encoder connection
l Incremental encoder (TTL encoder)
l Sin/cos encoder
^ 87
X25 Brake control connection ^ 61
X24 Motor connection ^ 60
Status displays
LED Operating state Check
Red Green
Off On Controller enabled, no fault
Off Blinking Controller inhibited (CINH), switch−on inhibit Code C0183
Blinking Off Fault/error (TRIP) active Code C0168/1
Blinking On Warning/FAIL−QSP active Code C0168/1