Xerox WorkCentre PE120-120i-3124 - Manual (Page 74)

Paper Handling 3.8
6 If you want the machine to stack the printed pages on the
rear output slot, open the rear door to use the rear output
slot.
C AUTION : Make sure to open the rear output slot when you print
on transparencies. If not, they may tear while exiting the machine.
7 After printing, fold away the paper support extension and
close the Bypass tray.
Using the Manual Feed Mode
You can manually load a sheet of print material in the Bypass
tray if you select Manual Feed in the Source option from the
Paper tab when you change print settings to print a document.
For details about changing print settings, see page 4.6.
Manually loading paper can be helpful when you want to check
print quality after each page is printed.
This loading procedure is almost the same as the procedure for
loading in the Bypass tray, except you load paper sheet-by-
sheet in the tray, send print data to print the first page, and
press Enter on the control panel to print each following page.
1 Lower the Bypass tray and unfold the paper support
extension.
2 Load a sheet of print material with the side to be printed
on facing up.