Xerox WorkCentre PE120-120i-3124 - Manual (Page 276)

Specifications E.8
N OTES :
• Do not use letterhead paper printed with low-temperature inks, such as those used in
some types of thermography.
• Do not use raised or embossed letterhead.
• The machine uses heat and pressure to fuse toner to the paper. Insure that any colored
paper or preprinted forms use inks that are compatible with this fusing temperature
(200 °C or 392 °F for 0.1 second).
Paper Specifications
Paper Output Capacity
Paper Storage Environment
Paper storage environmental conditions directly affect the feed operation.
Problems with feeding Ragged edges Use good quality paper.
Category Specifications
Acid content 5.5 pH or lower
Caliper 0.094 ~ 0.18 mm (3.0 ~ 7.0 mils)
Curl in ream Flat within 5 mm (0.02 in.)
Cut edge conditions Cut with sharp blades with no visible fray.
Fusing compatibility
Must not scorch, melt, offset, or release hazardous
emissions when heated to 200 °C (392 °F) for 0.1
second.
Grain Long grain
Moisture content 4 % ~ 6 % by weight
Output Location Capacity
Face-down output tray 150 sheets of 75 g/m 2 bond (20 lb) paper
Face-up output slot 1 sheet of 75 g/m 2 bond (20 lb) paper
Symptom Problem with Paper Solution