Xerox WorkCentre PE120-120i-3124 User Manual
Page 195
Troubleshooting
9.15
9
Memory Dial Full
You have tried to add a
fax job to the memory
when 15 fax jobs have
already been saved and
the memory for saving
memory transmission is
full.
Wait until some of the job in
memory are sent.
Or delete low priority delayed
jobs.
Memory Full
The memory is full.
Delete unnecessary documents
and retransmit after more
memory becomes available.
Alternatively, split the
transmission into more than one
operation.
[No Answer]
The receiving fax
machine has not
answered after several
redial attempts.
Try again. Make sure that the
receiving machine is operational.
NO. Not
Assigned
The one-touch or speed
dial location you tried to
use has no number
assigned to it.
Dial the number manually using
the number keypad or assign the
number. For storing a number, see
“Automatic Dialing” on page 7.19.
NO. Not
Available
You have tried to delete
the number for a delayed
fax job.
Verify the number to be deleted
and try again.
Or, delete the number after the
delayed fax job has been sent.
[Non-Xerox]
[Cartridge]
You have used an
unauthorized cartridge.
If you use non-xerox
cartridge, the machine
does not print.
You must use a Xerox approved
cartridge.
[No Paper]
Add Paper
The paper in the paper
tray has run out.
Load paper in the paper tray. See
Operation Not
Assigned
You are doing the Add/
Cancel operation, but
there are no jobs
waiting.
Check the display to see if there
are any scheduled jobs. The
display should indicate them in
Standby mode; for example,
Delay Fax.
[Paper Jam 0]
Open/Close Door
Paper has jammed in the
feeding area of the paper
tray.
Clear the jam. See page 9.5 and
[Paper Jam 1]
Open/Close Door
Paper has jammed in the
fuser area.
Clear the jam. See page 9.8.
Display
Meaning
Suggested solutions