Xerox WorkCentre PE120-120i-3124 - Manual (Page 116)

Copying 5.12
3 Press More Features or the scroll button (W or X) until “2
sides in 1pg” displays on the bottom line.
4 Press Enter to make your selection.
5 If necessary, customize the copy settings, including
number of copies, darkness, and original type, by using the
control panel buttons. See “Setting Copy Options” on
page 5.7.
6 Press Start to begin copying.
Your machine begins scanning the front side.
7 When “Set Backside” displays on the bottom line, open the
document cover and flip the document over. Close the
cover.
N OTE : If you press the Stop/Clear button or if no buttons are
pressed for approximately 30 seconds, the machine cancels the
copy job and returns to Standby mode.
8 Press Start again.
2 Up or 4 Up Copying
This special copy feature is available only when you load
documents in the ADF.
1 Load the documents to be copied in the ADF.
2 Press More Features.
3 Press More Features or the scroll button (W or X) until “2
UP” or “4 UP” displays on the bottom line.
4 Press Enter to make your selection.
5 If necessary, customize the copy settings, including
number of copies, darkness, and original type, by using the
control panel buttons. See “Setting Copy Options” on
page 5.7.
N OTE : You cannot adjust the copy size using the Reduce/
Enlarge button for making a 2 or 4 Up copy.
6 Press Start to begin copying.
1 2
3 4
1
2
S 2-up copying
S 4-up copying