Xerox WorkCentre PE120-120i-3124 - Manual (Page 213)

Troubleshooting 9.33
9
Troubleshooting PS Errors (WorkCentre PE120i Only)
The following situations are PS language specific and may occur when several printer
languages are being used.
N OTE : To receive a printed or screen-displayed message when PostScript errors occur,
open the Print Options window and click the desired selection next to the PostScript
errors section.
Problem Possible Cause Solution
PostScript file can
not be printed.
The PostScript driver
may not be installed
correctly.
• Install the PostScript driver,
referring to page B.2.
• Print a configuration page and verify
that the PS version is available for
printing.
• If the problem persists, contact a
service representative.
“This job contains
binary data...”
message appears.
The pure binary data
option is not supported
by the PostScript
driver.
Open the Properties of the PostScript
driver, click on PostScript, and click
on Advanced. The pure binary data
option is not supported. Choose
another option.
A PostScript error
page prints.
Print job may not be
PostScript.
Make sure that the print job is a
PostScript job. Check to see whether
the software application expected a
setup or PostScript header file to be
sent to the machine.
The optional Tray 2
is not selected in
the driver.
The printer driver has
not been configured to
recognize the optional
Tray 2.
Open the PostScript driver properties
and select the Device Settings tab
and set the Tray 2 option of the
Installable Options section to
Installed.
When print a
document in
Macintosh with
Acrobat Reader 6.0
or higher, colors
print incorrectly.
The resolution setting
in the printer driver
may not be matched
with that in Acrobat
Reader.
Make sure that the resolution setting
in your printer driver matches that in
Acrobat Reader.