Xerox WorkCentre PE120-120i-3124 - Manual (Page 278)

Specifications E.10
• Size: You should only use envelopes within the following size ranges.
N OTES :
• Use only the manual feeder to print envelopes.
• You may experience some paper jams when using any media with a length less than
140 mm (5.5 in.). This may be caused by paper that has been affected by
environmental conditions. For optimum performance, make sure you are storing and
handling the paper correctly. Please refer to “Paper Storage Environment” on page E.8.
Envelopes with Double Side Seams
Double side-seams construction has vertical seams at both ends of the envelope
rather than diagonal seams. This style may be more likely to wrinkle. Be sure the
seam extends all the way to the corner of the envelope as illustrated below.
Envelopes with Adhesive Strips or Flaps
Envelopes with a peel-off adhesive strip or with more than one flap that folds over to
seal must use adhesives compatible with the heat and pressure in the machine. The
extra flaps and strips might cause wrinkling, creasing or even jams and may even
damage the fuser.
Envelope Margins
The following gives typical address margins for a commercial #10 or DL envelope.
Minimum Maximum
Bypass tray
76 x 127 mm
(3 x 5 in.)
216 x 356 mm
(8.5 x 14 in.)
Type of Address Minimum Maximum
Return address 15 mm (0.6 in.) 51 mm (2 in.)
Delivery address 51 mm (2 in.) 90 mm (3.5 in.)
Correct
Incorrect