Xerox WorkCentre PE120-120i-3124 - Manual (Page 40)

Getting Started 2.14
For Network Printing (WorkCentre PE120i only)
You can attach your machine to a network using an Ethernet
cable (UTP cable with RJ.45 connector).
The WorkCentre PE120i has a built-in network interface card.
1 Make sure that both the machine and the computer are
turned off.
2 Plug one end of the Ethernet cable into the Ethernet
network port on your machine.
3 Plug the other end of the cable into a network LAN
connection.
N OTE : After connecting the machine, you need to configure the
network parameters on the control panel. See System
Administration Guide.
Turning the Machine On
1 Plug one end of the supplied three-pronged electrical cord
into the AC socket on the machine and the other end into a
properly grounded AC outlet.