Festo Контроллер позиционирования CPX-CMPX - Manual (Page 85)

3. Installation
3−5
Festo P.BE−CPX−SYS−EN en 0902e
Pre−assembling the plugs
and cables Connect the plugs and cables as follows (example):
1. Open the plugs/sockets as follows:
· Power supply socket:
Insert the mains power socket into the operating voltĆ
age connection of the CPX terminal. Unscrew the
housing of the socket.
Then remove the connecting part of the socket, which
is inserted in the operating voltage connection.
· Fieldbus socket and sensor plug (only with PG...):
Loosen the centre knurled nut.
1
Cable
2
Strain relief
3
Housing
4
Connecting part
1
2
3
4
Fig. 3/1: Individual parts of the socket and cable exit
2. Open the strain relief on the rear part of the housing.
Then pass the cable through.
3. Remove 5 mm of insulation from the end of the conducĆ
tors and fit cable−end sleeves on the stranded wires.
4. Connect the ends of the conductors.