Festo Контроллер позиционирования CPX-CMPX User Manual

Page 68

2. Assembly

2−24

Festo P.BE−CPX−SYS−EN en 0902e

Proceed as follows:

1. Make sure that the fastening surface can support the

weight of the CPX terminal.

2. Fit the H−rail (support rail EN 60715 − 35x7.5; width

35 mm, height 7.5 mm).
Make sure there is sufficient space to connect the comĆ
pressed air supply tubing.

3. Fasten the H−rail to the mounting surface at intervals of

approx. every 100 mm.

4. Fit an H−rail clamping unit to both the left and the right−

hand end plates and the pneumatic interface of the CPX
terminal.

5. Hang the CPX terminal onto the H−rail (see Fig. 2/11,

arrow A).

6. Swing the CPX terminal onto the H−rail (see Fig. 2/11,

arrow B). Make sure that the clamping element lies horiĆ
zontally to the H−rail.

H−rail

Clamping
component of the
H−rail clamping
unit

Retaining screw
of the H−rail
clamping unit

УУУ

ФФФФФ

ЦЦ

Fig. 2/11: Fitting a CPX terminal (here with CPA pneumatics) onto an H−rail