Festo Контроллер позиционирования CPX-CMPX - Manual (Page 134)

5. Diagnostics and error handling
5−20
Festo P.BE−CPX−SYS−EN en 0902e
Error numbers of error class 2
No. Handheld display Operating status Eliminating faults
0 [No error] No fault −
1 [General diagnosis] General diagnosis (module−
specific error) See manual for the relevant
module
2 [Short circuit] Short circuit/overload in senĆ
sor supply (SCS) or at output
(SCO) Eliminate short circuit/overĆ
load (see manual for the speĆ
cific module)
3 [Wire fracture/idling curĆ
rent I/O] Wire fracture/idling at current
input/output Check and, if necessary, reĆ
place the cable and connecĆ
ted sensors/actuators.
4 [Short circuit in actuator
supply] Failure of load voltage supply
due to short circuit/overload
(on output side) Check connected actuators
as well as their connections
5 [Undervoltage in power
supply] Undervoltage in power supply
(on input side) Eliminate undervoltage at
system supply or additional
supply (see Tab. 3/4 for pin
assignment)
6 ... 8 Reserved
9 [Lower limit exceeded] Fall below rated range Check signal area and paraĆ
meterised limit
10 [Upper limit exceeded] Rated range exceeded Check signal area and paraĆ
meterised limit
11 [Short circuit valve] Short circuit at valve Check valve and pneumatic
interface
12 Reserved
13 [Wire fracture (open load)] Wire fracture at valve (open
load) Check valve and pneumatic
interface
14 [Condition counter exceeĆ
ded] Limit value of the condition
counter exceeded Set or delete the limit value of
the condition counter by paraĆ
meterising
15 [Module/channel failure] Module/channel failed Check module (function/inĆ
stallation), replace if necesĆ
sary