Festo Контроллер позиционирования CPX-CMPX - Manual (Page 77)

2. Assembly
2−33
Festo P.BE−CPX−SYS−EN en 0902e
2. For CPX terminals with 4 or more interlinking blocks: you
will require additional mounting brackets of type
CPX−(M−)BG−RW−... every 100 or 150 mm. These are ready−
fitted on delivery.
3. For CPX terminals with MPA pneumatics:
Check whether you need additional wall supports for the
pneumatics module (see MPA pneumatics manual).
For CPX terminals with Midi/Maxi pneumatics:
Make sure that the spacer rings have been fitted (see
above in this section).
4. Configure the CPX terminal as follows (see also Tab. 2/5
and Tab. 2/6):
ć Any mounting position
ć Two screws at each of the end plates
ć Screws on the additional mounting elements of type
CPX−(M−)BG−RW−...
ć 2 or 3 screws on the pneumatic interface
Make sure there is sufficient space for connecting the power
supply cables and tubing and for heat dissipation.