Festo Контроллер позиционирования CPX-CMPX - Manual (Page 136)

5. Diagnostics and error handling
5−22
Festo P.BE−CPX−SYS−EN en 0902e
Error numbers of error class 2
No. Eliminating faults Operating status Handheld display
20 [Fault in parametrizing siĆ
gnal range] Fault in parameterising
(signal range) Check the parametrisation
undertaken and, if necessary,
undertake the parametrisaĆ
tion again with the correct paĆ
rameters.
21 [Fault in parametrizing data
format] Fault in parametrisation (data
format) Check the parametrisation
undertaken and, if necessary,
undertake the parametrisaĆ
tion again with the correct paĆ
rameters.
22 [Fault in parametrising
linear scaling] Fault in parametrisation
(linear scaling) Check the parametrisation
undertaken and, if necessary,
undertake the parametrisaĆ
tion again with the correct paĆ
rameters.
23 [Fault in filter meas.value] Fault in parametrisation
(measured value smoothing) Check the parametrisation
undertaken and, if necessary,
undertake the parametrisaĆ
tion again with the correct
parameters.
24 [Fault in parametrizing
lower limit] Fault in parametrisation
(lower limit) Check the parametrisation
undertaken and, if necessary,
undertake the parametrisaĆ
tion again with the correct
parameters.
25 [Fault in parametrizing
upper limit] Fault in parametrisation
(upper limit) Check the parametrisation
undertaken and, if necessary,
undertake the parametrisaĆ
tion again with the correct
parameters.
26 [Fault in actuator supply] Fault in actuator supply Eliminate short circuit/overĆ
load or check actuator supply,
if necessary, check connected
actuators
27 [Wrong device type mounĆ
ted] Missing or incorrect spare
part Replace module or spare part
(e.g. air filter)
See manual for the relevant
module