Festo Контроллер позиционирования CPX-CMPX - Manual (Page 207)

C. General information on parametrisation
C−9
Festo P.BE−CPX−SYS−EN en 0902e
Force
Fail safe
Idle mode
Idle mode channel X
Reset outputs
0 1
0
Idle mode
Assume idle mode
Holdlaststate
Memory card
Fail safe channel X
Reset outputs
0 1
0
Fail safe
Assume fault mode
Holdlaststate
0 1
Force channel X
Force mode
enable disable
1
disable
Idle mode is only
relevant for
certain fieldbus
protocols
Output signal (e.g. over fieldbus)
Memory card
System parameters
Module parameters
Module parameters
Module parameters
System parameters
System parameters
Output
Yes No
Yes No
Fieldbus communication fault
Idle mode status
1
Status LED of the respective output
Fig. C/4: Influencing output signals