Festo Контроллер позиционирования CPX-CMPX - Manual (Page 67)

2. Assembly
2−23
Festo P.BE−CPX−SYS−EN en 0902e
Variant Mounting points
1
2
1
CPX terminal with MPA pneumatics
Required mounting of the H−rail clampĆ
ing units:
Ĉ In the end plates:
each with one M4 screw 1
Ĉ In the pneumatic interface:
with an M4 screw 2
1 1
2
CPX terminal with VTSA pneumatics
Required mounting of the H−rail clampĆ
ing units:
Ĉ In the end plates:
each with one M4 screw 1
Ĉ In the pneumatic interface:
with an M4 screw 2
ТТ
ТТ
ТТ
ТТ
Т
Т
Т
Т
1
2
1
CPX terminal with CPA pneumatics
Required mounting of the H−rail clampĆ
ing units:
Ĉ In the end plates:
each with one M4 screw 1
Ĉ In the pneumatic interface:
with an M4 screw 2
Tab. 2/3: Required mounting points for H−rail mounting
For information about H−rail mounting of CPX terminals with
Midi/Maxi pneumatics, see section 2.4.3.