Festo Контроллер позиционирования CPX-CMPX - Manual (Page 171)

B. Parameters and data of the CPX terminal
B−17
Festo P.BE−CPX−SYS−EN en 0902e
Module parameter: Behaviour after short circuit/overload
Modules Depending on the function for modules with digital and analogue inputs and
outputs (see description on the respective module)
Function no. 4828 + m * 64 + 1 m = module number (0 ... 47)
Description Determines after a short circuit in the sensor supply or the outputs whether the
power is to remain switched off or whether it is to be switched on again automaĆ
tically.
Bit
0
1
3
Behaviour after short circuit/overload
Description
Short circuit/overload in sensor supply (SCS)
Short circuit/overload at the outputs (SCO)
Short circuit/overload at the analogue signal [Behaviour after]
[Behaviour after SCS]
[Behaviour after SCO]
[Behaviour after SCA]
Values 0 = Voltage/current remains switched off
1 = Switch voltage/current on again
[Leave switched off ]
[Resume]
Note With the setting Voltage/current remains switched off", you must switch the
power off/on or set/reset the relevant signals in order to apply power again.
Check which setting is necessary for reliable operation of your system. Further
information can be found in the manual for the CPX I/O modules.
Tab. B/13: Behaviour after short circuit/overload