Festo Контроллер позиционирования CPX-CMPX - Manual (Page 217)

C. General information on parametrisation
C−19
Festo P.BE−CPX−SYS−EN en 0902e
System parameters Settings Description
System Idle mode Reset outputs
(presetting) Reset all outputs/valves
Hold last state Retain current signal status for all outputs/
valves
Assume Idle mode
value Accept the signal status defined for the relevant
channel
Tab. C/6: System parameter System Idle mode
If Accept fault mode value" is activated, the signal states
defined by module parameter for the relevant channel will
become effective (see Tab. C/7).
Module parameters Settings Description
Idle mode Hold last state Retain current signal status
Idle state
(presetting) Accept the signal status defined by the Idle state
Idle state
Ĉ Digital signal Reset output
(presetting) Reset output signal (output/valve)
Set output Set output signal (output/valve)
Ĉ Analogue signal Analogue value Value of the analogue signal
Tab. C/7: Module parameters Idle mode" and Idle state"
Mode of operation
Functionally identical to Fail−safe parametrisation (see also
Fig. C/8 and Fig. C/9).