Allied Telesis AT 8000/8POE - Manual (Page 79)

AT-S81 Management Software User’s Guide
Section I: Using the Menus Interface 79
Note
The trap receiver must be one whose status is not “deleted.”
4. Enter the number for the trap you want to modify.
The following prompt is displayed:
Modify trap receiver entry number (I/C/B)>
The options are:
I - Modify the IP address of the trap receiver. To modify only the IP
address, type I and follow the prompts.
C - Modify the community name of the trap receiver. To modify only
the community name, type C and follow the prompts.
B - Modify both the IP address and community name of the trap
receiver. To modify both the IP address and the community name,
type B and follow the prompts.
Deleting a Trap
Receiver
When you delete a trap receiver, all the settings are removed from the
entry in the table. Instead of deleting a trap receiver, you may want to
disable it, as described in “Enabling or Disabling Trap Receivers” on
page 77.
To delete a trap receiver, perform the following procedure:
1. From the Main Menu, type B to select Basic Switch Configuration.
The Basic Switch Configuration Menu is shown in Figure 4 on page 32.
2. From the Basic Switch Configuration menu, type N to select SNMP
Configuration.
The SNMP Configuration menu is shown in Figure 19 on page 75.
3. Type D to select Delete SNMP Trap Receiver.
The following prompt is displayed:
Delete SNMP trap receivers->Enter entry number>
4. Type the number of the entry you want to delete.