Allied Telesis AT 8000/8POE - Manual (Page 213)

AT-S81 Management Software User’s Guide
Section I: Using the Menus Interface 213
5. Enter the IP address of the TFTP server.
6. Type F to select Set Configuration File Name.
The following prompt is displayed:
Enter file name>
7. Enter a name for the configuration file.
Note
There is no default name for the configuration file.
8. Type R to select Set Retry Count.
The following prompt is displayed:
Enter retry count>
9. Enter the number of times you want the switch to retry in the event a
problem occurs during the upload process. The range is 1 to 20. The
default is 5 times.
10. To begin the upload, type U to select Upload Configuration File.
The following prompt is displayed:
Upload file? (Y/N)>
11. Type Y for yes to begin the uploading or N for no to cancel the
procedure.
Downloading a
Configuration
File
To download a configuration file onto the switch from a TFTP server,
perform the following procedure:
1. From the Main Menu, type T to select Switch Tools.
The Switch Tools Configuration Menu is shown in Figure 11 on page
50.
2. From the Switch Tools Menu, type C to select Configuration File
Upload/Download.
The Configuration File Upload/Download Menu is shown in Figure 58
on page 212.
3. From the Configuration File Upload/Download Menu, type T to select
TFTP Configuration File Upload/Download.
The TFTP Configuration File Upload/Download Menu is shown in
Figure 59 on page 212.