Allied Telesis AT 8000/8POE - Manual (Page 130)

Chapter 9: Virtual LANs and GVRP
130 Section I: Using the Menus Interface
4. Enter the VLAN ID of the VLAN you want to delete. You can enter only
one VID.
Note
The VLAN is immediately deleted with no confirmation prompt.
Note
You cannot delete the Default VLAN which has a VID of 1.
The VLAN Management Menu is updated to show that the VLAN is
deleted. The untagged port members of a deleted VLAN are
automatically returned to the Default_VLAN with a PVID of 1.
Resetting to the
Default VLAN
The following procedure for deletes all VLANs, except the Default_VLAN,
on a switch. To delete selected VLANs, refer to “Deleting a VLAN” on
page 129.
To reset to the default VLAN, perform the following procedure:
1. From the Main Menu, type A to select Advanced Switch
Configuration.
The Advanced Switch Configuration Menu is shown in Figure 21 on
page 87.
2. From the Advanced Switch Configuration Menu, type V to select
VLAN Management.
The VLAN Management Menu is shown in Figure 29 on page 122.
3. Type R to select Reset VLAN to Default.
The following prompt is displayed:
Are you sure to reset VLAN configuration to factory
default (Y/N)>
4. Type Y for Yes.
The following prompt is displayed:
Reset to factory default completed, press any key to
continue.
5. Press any key.