Allied Telesis AT 8000/8POE - Manual (Page 303)

AT-S81 Management Software User’s Guide
Section II: Web Browser Interface 303
Configuring RSTP Port Settings
This section contains the following topics:
 “Configuring the Basic RSTP Port Settings,” next
 “Configuring the Advanced RSTP Port Settings” on page 304
Configuring the
Basic RSTP Port
Settings
To configure the basic RSTP port settings, perform the following
procedure:
1. From the Basic Config menu, select Rapid Spanning Tree > RSTP
Basic Port Config.
The RSTP Basic Port Configuration page opens, as shown in
Figure 92.
Figure 92. RSTP Basic Port Configuration Page
2. In the STP Status column for the port you want to configure, select
either Enable or Disable for the STP status.
3. In the Priority column for the port you want to configure, type a
number for the port priority.
Port priority is described in “Port Priority” on page 156.
4. In the Path Cost column for the port you want to configure, type a
number for the Path Cost.
Path cost is described in “Path Costs and Port Costs” on page 155.
5. Click Apply.