Allied Telesis AT 8000/8POE - Manual (Page 341)

AT-S63 Management Software Menus Interface User’s Guide
Section III: Using the Command Line Interface 341
VLAN Example
To create a new VLAN with a VLAN ID of 2, access the Interface
Configuration mode and specify the VLAN ID. Perform the following
procedure.
1. From the User EXEC mode, enter:
enable
You now have access to the Privileged EXEC Configuration mode
as indicated by the Switch(config)# prompt.
2. From the Privileged EXEC Configuration mode, enter:
configure
You now have access to the Global Configuration mode as
indicated by the Switch(config)# prompt.
3. Create a VLAN with a VLAN ID of 2 by entering:
interface vlan2
You have created a VLAN with an ID of 2. You have access to the
VLAN Configuration mode as indicated by the Switch(config-vlan)#
prompt.