Allied Telesis AT 8000/8POE - Manual (Page 251)

AT-S81 Management Software User’s Guide
Section II: Web Browser Interface 251
speed and duplex mode manually.
 Allied Telesis does not recommend manually setting a
10/100/1000Base-T twisted pair port to either 1000
Mbps full duplex or 1000 Mbps half duplex. For 1000
Mbps operation, Allied Telesis recommends setting the
port to Auto-Negotiation.
 The only valid setting for an optional SFP port is Auto-
Negotiation.
Flow Ctrl
The current flow control setting on the port. The switch uses a special
pause packet to notify the end node to stop transmitting for a specified
period of time. The possible values are:
Enabled - The port uses flow control. This is the default setting for
all ports on the switch.
Disabled - The port does not use flow control.
MAC Address
The port’s MAC address. You cannot change this setting.
3. Click Apply.
4. To view or configure the parameter settings on another port, click Go
to Port and select the port from the list,
5. Repeat step 2 in this procedure to configure the settings
6. Click Apply.
To return to the front panel page, click Return To Front Panel.