Disabling port mirroring – Allied Telesis AT 8000/8POE User Manual
Page 271
AT-S81 Management Software User’s Guide
Section II: Web Browser Interface
271
Disabling Port Mirroring
To disable port mirroring, perform the following procedure:
1. From the Advanced Config menu, select Port Mirroring.
The Port Mirroring page is shown in Figure 80 on page 270.
2. From the Mirroring Status list, select Disable and click Apply.
Port mirroring is immediately disabled on the switch. You can now use
the mirroring port for regular network operations.
See also other documents in the category Allied Telesis Computer Accessories:
- Rapier Series (22 pages)
- Layer 3 Gigabit Ethernet Switch x600-48Ts (110 pages)
- 86222-27 (46 pages)
- 4000 Series (12 pages)
- Switch Controller (12 pages)
- AT 8000S/16 (3 pages)
- x900-24 series (21 pages)
- SB244-03 (8 pages)
- 48i (6 pages)
- AT 8000/8POE (56 pages)
- x900-48 series (38 pages)
- Rapier Switch (4 pages)
- Rapier Switch (11 pages)
- Rapier Switch (74 pages)
- Rapier Switch (66 pages)
- SB251-08 (12 pages)
- x900-24x (5 pages)
- AR750S-DP (31 pages)
- SB251-13 (66 pages)
- SB251-01 (4 pages)
- AT FH812U AT-FH812U (36 pages)
- Rapier i Series (26 pages)
- AR44xS series (84 pages)
- 28 (4 pages)
- Layer 3 Gigabit Ethernet Switch x600-24Ts/XP (72 pages)
- AlliedWare Plus 5.2.1 (5 pages)
- AR700 Series (53 pages)
- Series (7 pages)
- AT 9748TS/XP AT-9748TS/XP-20 (3 pages)
- x900-48FE (232 pages)
- SWITCH AND SWITCHBLADE X900 (23 pages)
- x900-48 (22 pages)
- 86241-06 (30 pages)
- AlliedWare Plus (40 pages)
- SB251-10 (14 pages)
- AlliedWare OS (56 pages)