Allied Telesis AT 8000/8POE - Manual (Page 132)

Chapter 9: Virtual LANs and GVRP
132 Section I: Using the Menus Interface
 GVRP is only aware of those VLANs that have active
nodes, or where at least one end node of a VLAN has
established a valid link with a switch. GVRP is not
aware of a VLAN if there are no active end nodes or if
no end nodes have established a link with the switch.
Enabling or
Disabling GVRP
GVRP is disabled by default.
To enable or disable GVRP, perform the following procedure:
1. From the Main Menu, type A to select Advanced Switch
Configuration.
The Advanced Switch Configuration Menu is shown in Figure 21 on
page 87.
2. From the Advanced Switch Configuration Menu, type  to select VLAN
Management.
The VLAN Management Menu is shown in Figure 29 on page 122.
3. From the VLAN Management Menu, type G to select Set GVRP
Status.
The following prompt is displayed:
Enable or Disable GVRP status (E/D)>
4. Type E to enable GVRP or D to disable it.