Allied Telesis AT 8000/8POE User Manual
Page 53
AT-S81 Management Software User’s Guide
Section I: Using the Menus Interface
53
3. Type I to select Set Target IP Address.
The following prompt is displayed:
Enter new target IP address>
4. Enter the IP address of the node you want the switch to ping.
5. Type N to select Set Number of Requests.
The following prompt is displayed:
Enter new number of requests>
6. Enter the number of ping requests you want the switch to perform. The
range is 1 to 10. The default is 10.
7. Type T to select Set Timeout Value.
The following prompt is displayed:
Enter new timeout value>
8. Enter the length of time in seconds the switch is to wait for a response
before assuming that a ping has failed. The range is 1 to 5 seconds.
The default is 3 seconds.
9. Type E to select Execute Ping.
The following prompt is displayed:
Execute ping or Clean ping data (E/C)>