Allied Telesis AT 8000/8POE - Manual (Page 138)

Chapter 10: Quality of Service (QoS)
138 Section I: Using the Menus Interface
3. From the Quality of Service Configuration Menu, type T to select
Traffic Class Configuration.
The Traffic Class Configuration Menu is shown in Figure 34.
Figure 34. Traffic Class Configuration Menu
4. To enable or disable QoS, do the following:
a. Type S to select Set Status.
The following prompt is displayed:
Enable or Disable QoS (E/D) >
b. Type E to enable QoS or D to disable it. The default setting is
disabled. When disabled, all tagged packets are stored in the
lowest priority queue of a port.
AT-8000/8POE Local Management System
Quality of Service Configuration -> Traffic Class Configuration Menu
QoS Status : Disabled
Traffic Class Queue
------------- -----
0 0
1 0
2 0
3 1
4 2
5 2
6 3 3 : Highest
7 3 0 : Lowest
----------------------- ------------------------------------
Set [S]tatus
Set [P]riority Queue
[Q]uit to previous Page
Command>