Enabling or disabling gvrp – Allied Telesis AT 8000/8POE User Manual
Page 289
AT-S81 Management Software User’s Guide
Section II: Web Browser Interface
289
Enabling or Disabling GVRP
The GARP VLAN Registration Protocol (GVRP) allows network devices to
share VLAN information. For more information about GVRP, refer to
“GVRP” on page 131.
To enable or disable GVRP, perform the following procedure:
1. From the Advanced Config menu, select VLAN Config. > VLAN Info.
The VLAN Information page is shown in Figure 84 on page 282.
2. From the GVRP Status list, choose Enable or Disable.
3. Click Apply.
See also other documents in the category Allied Telesis Computer Accessories:
- Rapier Series (22 pages)
- Layer 3 Gigabit Ethernet Switch x600-48Ts (110 pages)
- 86222-27 (46 pages)
- 4000 Series (12 pages)
- Switch Controller (12 pages)
- AT 8000S/16 (3 pages)
- x900-24 series (21 pages)
- SB244-03 (8 pages)
- 48i (6 pages)
- AT 8000/8POE (56 pages)
- x900-48 series (38 pages)
- Rapier Switch (74 pages)
- Rapier Switch (66 pages)
- Rapier Switch (4 pages)
- Rapier Switch (11 pages)
- SB251-08 (12 pages)
- x900-24x (5 pages)
- AR750S-DP (31 pages)
- SB251-13 (66 pages)
- SB251-01 (4 pages)
- AT FH812U AT-FH812U (36 pages)
- Rapier i Series (26 pages)
- AR44xS series (84 pages)
- 28 (4 pages)
- Layer 3 Gigabit Ethernet Switch x600-24Ts/XP (72 pages)
- AlliedWare Plus 5.2.1 (5 pages)
- AR700 Series (53 pages)
- Series (7 pages)
- AT 9748TS/XP AT-9748TS/XP-20 (3 pages)
- x900-48FE (232 pages)
- SWITCH AND SWITCHBLADE X900 (23 pages)
- x900-48 (22 pages)
- 86241-06 (30 pages)
- AlliedWare Plus (40 pages)
- SB251-10 (14 pages)
- AlliedWare OS (56 pages)