Allied Telesis AT 8000/8POE - Manual (Page 129)

AT-S81 Management Software User’s Guide
Section I: Using the Menus Interface 129
To add a tagged port to the VLAN, perform the following procedure:
1. From the Main Menu, type A to select Advanced Switch
Configuration.
The Advanced Switch Configuration Menu is shown in Figure 21 on
page 87.
2. From the Advanced Switch Configuration Menu, type V to select VLAN
Management.
The VLAN Management Menu is shown in Figure 29 on page 122.
3. To add a tagged port, type A for Add Member.
The following prompt is displayed:
Add member->Enter port number >
4. Enter the number of the port. You can add more than one port at a
time. You can specify the ports individually (i.e., 2,5,11), as a range
(i.e., 4-7), or both (i.e., 2,5,11-15).
5. To remove a tagged port, type R for Remove Member.
The following prompt is displayed:
Delete number -> Enter port number >
6. Enter the number of the tagged port you want to remove. You can
remove more than one port at a time. You can specify the ports
individually (i.e., 2,5,11), as a range (i.e., 4-7), or both (i.e., 2,5,11-15).
Deleting a VLAN
To delete a VLAN, perform the following procedure:
1. From the Main Menu, type A to select Advanced Switch
Configuration.
The Advanced Switch Configuration Menu is shown in Figure 21 on
page 87.
2. From the Advanced Switch Configuration Menu, type V to select VLAN
Management.
The VLAN Management Menu is shown in Figure 29 on page 122.
3. Type D to select Delete VLAN.
The following prompt is displayed:
Enter VLAN ID >