Allied Telesis AT 8000/8POE - Manual (Page 246)

Chapter 20: Port Configuration
246 Section II: Web Browser Interface
Viewing and Configuring Multiple Ports
This procedure allows you to configure the ports on the switch using the
Port Configuration page. This page allows you to view and configure the
parameter settings of all the switch ports at one time.
To configure the ports, perform the following procedure:
1. From the Basic Config menu, select Port Config.
The Port Configuration page opens, as shown in Figure 73. The page
lists all the ports on the switch and their current settings.
Figure 73. Port Configuration Page
2. Adjust the port settings as needed. Not all parameters are adjustable.
The parameters are:
Port Index
The port number. You cannot change this parameter.
Trunk
The trunk group number. A number in this column indicates that the
port has been added to a trunk. For information about configuring a
trunk, refer to Chapter 22, “Port Trunking” on page 261.
Type
The port type. The port type is 10/100TX for 10/100Base-T twisted pair
ports and 1000Base-F for the SFP fiber port.
Link Status
The status of the link between the port and the end node connected to
the port. The possible values are:
Up - A valid link exists between the port and the end node.
Down - A valid link is not established on the port.