Chapter 32, Getting started with the command line interface – Allied Telesis AT 8000/8POE User Manual
Page 331
Section III: Using the Command Line Interface
331
Chapter 32
Getting Started with the Command Line
Interface
This chapter describes the command modes of the AT-S81 management
software command line interface and how to access them. This chapter
includes the following sections:
“CLI Command Modes Introduction” on page 332
“Starting the Command Line Interface” on page 342
See also other documents in the category Allied Telesis Computer Accessories:
- Rapier Series (22 pages)
- Layer 3 Gigabit Ethernet Switch x600-48Ts (110 pages)
- 86222-27 (46 pages)
- 4000 Series (12 pages)
- Switch Controller (12 pages)
- AT 8000S/16 (3 pages)
- x900-24 series (21 pages)
- SB244-03 (8 pages)
- 48i (6 pages)
- AT 8000/8POE (56 pages)
- x900-48 series (38 pages)
- Rapier Switch (74 pages)
- Rapier Switch (66 pages)
- Rapier Switch (4 pages)
- Rapier Switch (11 pages)
- SB251-08 (12 pages)
- x900-24x (5 pages)
- AR750S-DP (31 pages)
- SB251-13 (66 pages)
- SB251-01 (4 pages)
- AT FH812U AT-FH812U (36 pages)
- Rapier i Series (26 pages)
- AR44xS series (84 pages)
- 28 (4 pages)
- Layer 3 Gigabit Ethernet Switch x600-24Ts/XP (72 pages)
- AlliedWare Plus 5.2.1 (5 pages)
- AR700 Series (53 pages)
- Series (7 pages)
- AT 9748TS/XP AT-9748TS/XP-20 (3 pages)
- x900-48FE (232 pages)
- SWITCH AND SWITCHBLADE X900 (23 pages)
- x900-48 (22 pages)
- 86241-06 (30 pages)
- AlliedWare Plus (40 pages)
- SB251-10 (14 pages)
- AlliedWare OS (56 pages)