Allied Telesis AT 8000/8POE - Manual (Page 65)

AT-S81 Management Software User’s Guide
Section I: Using the Menus Interface 65
Setting a Port’s Speed and Duplex Mode
To change a port’s speed or duplex mode, perform the following
procedure:
1. From the Main Menu, type B to select Basic Switch Configuration.
The Basic Switch Configuration Menu is shown in Figure 4 on page
32.
2. From the Basic Switch Configuration Menu, type P to select Port
Configuration.
The Port Configuration Menu is shown in Figure 17 on page 62.
3. Type M to select Set Mode.
The following prompt is displayed:
Set Mode -> Enter port number >
4. Enter the number of the port whose speed or duplex mode you want to
change. You can configure only one port at a time.
The following prompt is displayed:
Enter new mode for port n (a/h/H/F/f/t/T)>
5. Enter the letter that corresponds to the desired speed and duplex
mode setting for the port. The port settings are:
a - Auto: The port uses Auto-Negotiation to set its speed and duplex
mode. This is the default setting for all ports.
h - 10 Mbps, half-duplex
H - 100 Mbps, half-duplex
f - 10 Mbps, full-duplex
F - 100 Mbps, full-duplex
When you select a setting, note the following:
 When a twisted pair port on the switch is set to Auto-
Negotiation, the default setting, the end node should
also be using Auto-Negotiation to prevent a duplex
mode mismatch. A switch port using Auto-Negotiation
defaults to half-duplex if it detects that the end node is
not using Auto-Negotiation. This can result in a
mismatch if the end node is operating at a fixed duplex
mode of full-duplex. To avoid this problem when